March 19, 2024

The NightCap

The Market: An initial gap higher was immediately sold but an afternoon surge helped the Dow, S&P and NASDAQ finish higher while greatly paring losses in the Russell 2000.  Downside momentum seems to be waning and today’s mixed session is likely pointing to a bottom.  In all likelihood that bottom will only be short-term but we will have to see how the action takes place. Ideally, for the start of a move higher, we would like to see a gap down (or strong move lower in early trading) tomorrow which takes us near or below today’s lows which is again…

The NightCap

The Market: We expected to see a tight trading range until the FOMC statement but instead we saw buyers in advance of the statement as the S&P 500 (SPY) pressed higher.  The the announcement came and there was a sharp sell-off but buyers came right back and all 4 major market indices on the WSC Scoreboard finished above the pre-FOMC announcement highs. As was expected by many, the FOMC left the Fed Fund Rates unchanged but, based on the comments, it appears a rate hike is on the table for December if the data warrants.  We also saw the committee…

Strong start to the week led by Tech

The Market:     Reporting EPS 7/14/15 Pre-Market:   Reporting EPS 7/14/15 After the Close:   Analyst Comments:

S&P 500 holds 200 day SMA

The Market: Sorry no comments tonight — traveling the remainder of this week.      Reporting EPS After the Close this week:   Reporting EPS Pre-Market this week:   Analyst Comments:

Early volatility wanes, dull day

Index & Sector performance 6/2/14 The Market: Overall a quiet day in the market if you look at the overall performance but that does not show the early volatility the market saw when the S&P 500 futures dropped roughly 10 points at the open to only “V” bottom and spike back up near where the drop occurred.  After that it was tight trading the rest of the day leaving a small up day in the Dow & S&P with the NASDAQ and Russell 2000 closing on the downside. Today there was some drama around ISM Manufacturing PMI after it was…